380.256 PEOPLE
People | Locations | Statistics |
---|---|---|
Seuring, Stefan |
| |
Nor Azizi, S. |
| |
Pato, Margarida Vaz |
| |
Kölker, Katrin |
| |
Huber, Oliver |
| |
Király, Tamás |
| |
Spengler, Thomas Stefan |
| |
Al-Ammar, Essam A. |
| |
Dargahi, Fatemeh |
| |
Mota, Rui |
| |
Mazalan, Nurul Aliah Amirah |
| |
Macharis, Cathy | Brussels |
|
Arunasari, Yova Tri |
| |
Nunez, Alfredo | Delft |
|
Bouhorma, Mohammed |
| |
Bonato, Matteo |
| |
Fitriani, Ira |
| |
Autor Correspondente Coelho, Sílvia. |
| |
Pond, Stephen |
| |
Okwara, Ukoha Kalu |
| |
Toufigh, Vahid |
| |
Campisi, Tiziana | Enna |
|
Ermolieva, Tatiana |
| |
Sánchez-Cambronero, Santos |
| |
Agzamov, Akhror |
|
Navarro, R.
in Cooperation with on an Cooperation-Score of 37%
Topics
Publications (24/24 displayed)
- 2024Evaluation of different FW-H surfaces and modal decomposition techniques for the acoustic analysis of UAV propellers through detached eddy simulationscitations
- 2022Quantitative validation of an in-flow water condensation model for 3D-CFD simulations of three-way junctions using indirect condensation measurementscitations
- 2021Analysis of condensation and secondary flows at three-way junctions using optical visualization techniques and computational fluid dynamicscitations
- 2021Development of an experimental test bench and a psychrometric model for assessing condensation on a low-pressure exhaust gas recirculation coolercitations
- 2020Effect of Numerical Configuration on Predicted EGR Cylinder-to-Cylinder Dispersioncitations
- 2020Numerical modeling of centrifugal compressors with heterogeneous incoming flow due to low pressure exhaust gas recirculationcitations
- 2019Analysis of the impact of the geometry on the performance of an automotive centrifugal compressor using CFD simulationscitations
- 2019A zonal approach for estimating pressure ratio at compressor extreme off-design conditionscitations
- 2019Validation and sensitivity analysis of an in-flow water condensation model for 3D-CFD simulations of humid air streams mixingcitations
- 2018Autonomous robotic system for tunnel structural inspection and assessmentcitations
- 2018Centrifugal compressor influence on condensation due to Long Route-Exhaust Gas Recirculation mixingcitations
- 2017Effect of the inlet geometry on performance, surge margin and noise emission of an automotive turbocharger compressorcitations
- 2016Numerical and experimental analysis of automotive turbocharger compressor aeroacoustics at different operating conditionscitations
- 2016Compressor Efficiency Extrapolation for 0D-1D Engine Simulationscitations
- 2015Influence of tip clearance on flow behavior and noise generation of centrifugal compressors in near-surge conditionscitations
- 2015Aeroacoustical and flow analysis in an automotive turbocharger centrifugal compressor by CFD calculations and measurements
- 2015Simulations and measurements of automotive turbocharger compressor whoosh noisecitations
- 2015Acoustic characterization of automotive turbocompressorscitations
- 2014Methodology for experimental validation of a CFD model for predicting noise generation in centrifugal compressorscitations
- 2014Development of a segregated compressible flow solver for turbomachinery simulations
- 2013Characterization of a radial turbocharger turbine in pulsating flow by means of CFD and its application to engine modelingcitations
- 2013Analysis of the influence of different real flow effects on computational fluid dynamics boundary conditions based on the method of characteristicscitations
- 2013Set-up analysis and optimization of cfd simulations for radial turbines
- 2011Coupling methodology of 1D finite difference and 3D finite volume CFD codes based on the Method of Characteristicscitations
Places of action
Organizations | Location | People |
---|